NC03U

Upgrade the Shuttle NC03U WLAN module to WLN-M

Open the two NC03U covers from both sides.
Disconnect current WLAN antenna connector.
Undo three screws and remove the mainboard out of the chassis.
Gently open the perforations for the WLAN antennas in the NC03U chassis.
Unpack the Shuttle WLN-M accessory.
Use the short cables (21 and 29 cm) from the WLN-M accessory. Put the SMA connectors of the antenna cables into the holes and fix them.
Insert the mainboard again and fix it with three screws.
Remove the currrent WLAN card. Insert the new WLAN card from the WLN-M accessory kit. Connect two antenna cables to the IPEX4 ports of the WLAN card.
Install the chassis cover to the NC03U.
Mount the two antennas to the SMA connectors - ready.

The unit can be operated at a maximum ambient temperature of 50°C (122°F).
Do not expose it to temperatures below 0°C (32°F) or above 50°C (122°F).

For safety reasons, please ensure that the power cord is disconnected before opening the case.

This motherboard does only support 1.2V DDR4 memory modules.

Locate the SO-DIMM (DIMMB1) slot on the motherboard.
Align the notch of the memory module with the one of the memory slot.
Gently insert the memory module into the slot in a 45-degree angle.
Carefully push down the memory module until it snaps into the locking mechanism.

If the DIMMA1 slot should also be equipped with a memory module, please proceed with the following steps.

This model supports 2.5“ drives (HDDs and SSDs) up to a thickness of 15mm.

Mount the drive in the bracket with four screws.
Install the drive sitting in its bracket in the chassis and secure with four screws. Tear off the adhesive tape of the SATA cable.
Connect the drive with the cable.
Replace the cover and refasten the two screws.