Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revisionBoth sides next revision | ||
| faq:omninas:kd20 [2019/05/22 09:33] – Shuttle | faq:omninas:kd20 [2020/01/29 15:53] – [OMNINAS Firmware update via USB] SH | ||
|---|---|---|---|
| Line 117: | Line 117: | ||
| - | ===== OMNINAS Firmware update via USB ===== | ||
| - | <WRAP center round important 60%> | ||
| - | **Note**: This instruction is intended for advanced users. | ||
| - | </ | ||
| - | - Download the following file suitable for your Shuttle OMNINAS: | ||
| - | * [[KS10]] Firmware: http:// | ||
| - | * [[KD20]] Firmware: http:// | ||
| - | * [[KD21]] Firmware: http:// | ||
| - | * [[KD22]] Firmware: http:// | ||
| - | - Unzip the ZIP file downloaded onto a FAT32 formatted, empty USB 2.0 stick (sticks with USB 3.0 interface are not suitable for this process). | ||
| - | - Remove the LAN cable and the hard disk(s) from your NAS. To reinsert correctly, note the order of hard disk 1 and 2. | ||
| - | - Insert the USB stick into the front USB port on the NAS and start the unit. | ||
| - | - The LEDs on the NAS will illuminate red and flash during the process, which takes a few minutes. The unit will switch off automatically later. | ||
| - | - Remove the USB stick and reinsert the hard disks into the unit in the correct order. | ||
| - | - The update is completed by starting the NAS by pressing the power button. | ||
| ===== " | ===== " | ||