Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | |||
faq:xpc_accessories:wln-m [2017/11/15 07:07] – Shuttle | faq:xpc_accessories:wln-m [2018/04/11 08:49] (current) – Added Upgrade for NC03 Shuttle | ||
---|---|---|---|
Line 8: | Line 8: | ||
* This WLAN card is a Combo card which supports both WLAN and Bluetooth. | * This WLAN card is a Combo card which supports both WLAN and Bluetooth. | ||
* The transmission protocol of the PCI-Express interface is less complex as compared to USB which helps keep processor load lower. | * The transmission protocol of the PCI-Express interface is less complex as compared to USB which helps keep processor load lower. | ||
+ | |||
+ | ===== Upgrade the Shuttle NC03U WLAN module to WLN-M ===== | ||
+ | - Open the two NC03U covers from both sides. | ||
+ | - Disconnect current WLAN antenna connector.\\ {{: | ||
+ | - Undo three screws and remove the mainboard out of the chassis.\\ {{: | ||
+ | - Gently open the perforations for the WLAN antennas in the NC03U chassis.\\ {{: | ||
+ | - Unpack the Shuttle WLN-M accessory.\\ {{: | ||
+ | - Use the short cables (21 and 29 cm) from the WLN-M accessory. Put the SMA connectors of the antenna cables into the holes and fix them.\\ {{: | ||
+ | - Insert the mainboard again and fix it with three screws.\\ {{: | ||
+ | - Remove the currrent WLAN card. Insert the new WLAN card from the WLN-M accessory kit. Connect two antenna cables to the IPEX4 ports of the WLAN card.\\ {{: | ||
+ | - Install the chassis cover to the NC03U. | ||
+ | - Mount the two antennas to the SMA connectors - ready.\\ {{: | ||
==== Related links ==== | ==== Related links ==== | ||
{{backlinks> | {{backlinks> |