This is an old revision of the document!


SG77G5

The maximum size of a card that fits in the G-Series is 206 mm (L) × 98 mm (H) × 16 mm (D). But due to the different layout designs of each model and VGA card, we strongly suggest to check our VGA support list for each model or test before purchasing the VGA card.

This may be caused by an incorrect LAN firmware and chipset version. Please install the “Broadcom Advanced Control Suite” from your driver CD. You can check, if the versions match.

If the ASIC Version is BCM5705 A3 and Firmware Version is 5788, please follow the procedures below:

  1. Prepare a boot disk, download this patch and unzip the files on a disk.
  2. Shut down the SB77G5 and unplug the power cord for 30 seconds.
  3. Boot the system with this boot disk and enter 5705.

Please note: This procedure only works if the ASIC version is 5705 and the Firmware version 5788.

In order to install Windows 2000 or Windows XP RAID drivers on the SB77G5, a floppy drive and floppy disk with the RAID driver is needed.

Before you start you will need to create a Intel RAID Driver Floppy Disk (create a Intel RAID Driver Floppy Disk or download the driver from here and extract/UnZip into a Floppy Disk directly): If you have the “Intel RAID Driver” disk from your XPC box, skip this step.

  1. On a system running Windows, insert Motherboard Driver CD.
  2. Insert a blank floppy diskette into the floppy drive.
  3. Double-click on the D:\Intel\Raid\F6 install\F6 install.exe and answer all prompts presented (Assumes your CD ROM Drives label is D.)
  4. When installation is complete, your floppy should contain the following files: iaStor.cat, iaStor.inf, iaStor.cat, License.txt, readme.txt and TXTSETUP.oem.
  5. Go into the BIOS setup utility and enable Drive A and Onboard FDC Controller.
  6. Enable Drive A.
  7. Enable Onboard FDC Controller.
  8. Begin Windows installation
  9. Press F6 function key when the Raid setup message string come up.
  10. Press S key to select RAID driver.
  11. Insert the floppy disk you just made into the floppy drive.
  12. Select the driver for your operating system.
  13. After the driver has been installed, press Enter to continue installing Windows.
  • Last modified: 2017/01/27 15:07
  • by christian