Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
faq:xpc_cube:sd11g5 [2017/01/31 09:13]
CS [How should I set the jumper(J1) when there is a PCI-E VGA card insert?]
faq:xpc_cube:sd11g5 [2017/07/17 11:25]
Shuttle
Line 1: Line 1:
 ====== SD11G5 ====== ====== SD11G5 ======
-{{section>​faq:​xpc_cube:​sg33g5#​post_issuejp4_jumper_setting_for_shuttle_g5_models&​firstseconly&​nofooter&​noeditbutton&​noreadmore}}+{{section>​faq:​xpc_cube:​sg33g5#​post_issue_on_shuttle_g5_models_-_check_setting_of_jumper_jp4&​firstseconly&​nofooter&​noeditbutton&​noreadmore}}
  
 ===== How do I set jumper 1 (J1), if there is a PCI-E VGA card to install? ===== ===== How do I set jumper 1 (J1), if there is a PCI-E VGA card to install? =====
 If you want to use a PCI-E VGA card with SD11G5, you will need to set jumper 1 (J1) to position 1-2. If you want to use a PCI-E VGA card with SD11G5, you will need to set jumper 1 (J1) to position 1-2.
  
-===== How do I use onboard DVI or TV-out? ===== +===== How do I use the onboard DVI or TV-out? ===== 
-You may refer to manual ​pg31 for the monitor hot-key control list.+Please ​refer to the manual ​PG31 for the monitor hot-key control list.
  
 ''​ctrl+alt+F1''​ = D-sub, ''​ctrl+alt+F2''​ = TV-out and ''​ctrl+alt+F4''​ = DVI ''​ctrl+alt+F1''​ = D-sub, ''​ctrl+alt+F2''​ = TV-out and ''​ctrl+alt+F4''​ = DVI
  • faq/xpc_cube/sd11g5.txt
  • Last modified: 2017/07/17 11:25
  • by Shuttle