Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
faq:xpc_cube:sd11g5 [2017/01/31 09:13] – [How should I set the jumper(J1) when there is a PCI-E VGA card insert?] christianfaq:xpc_cube:sd11g5 [2021/09/02 13:39] (current) TS
Line 1: Line 1:
 ====== SD11G5 ====== ====== SD11G5 ======
-{{section>faq:xpc_cube:sg33g5#post_issuejp4_jumper_setting_for_shuttle_g5_models&firstseconly&nofooter&noeditbutton&noreadmore}} +{{section>faq:xpc_cube:sg33g5#post_issue_on_shuttle_g5_models_-_check_setting_of_jumper_jp4&firstseconly&nofooter&noeditbutton&noreadmore}} 
 +{{section>faq:hardware:graphics#g-series&firstseconly&nofooter&noeditbutton&noreadmore}}
 ===== How do I set jumper 1 (J1), if there is a PCI-E VGA card to install? ===== ===== How do I set jumper 1 (J1), if there is a PCI-E VGA card to install? =====
 If you want to use a PCI-E VGA card with SD11G5, you will need to set jumper 1 (J1) to position 1-2. If you want to use a PCI-E VGA card with SD11G5, you will need to set jumper 1 (J1) to position 1-2.
  
-===== How do I use onboard DVI or TV-out? ===== +===== How do I use the onboard DVI or TV-out? ===== 
-You may refer to manual pg31 for the monitor hot-key control list.+Please refer to the manual PG31 for the monitor hot-key control list.
  
 ''ctrl+alt+F1'' = D-sub, ''ctrl+alt+F2'' = TV-out and ''ctrl+alt+F4'' = DVI ''ctrl+alt+F1'' = D-sub, ''ctrl+alt+F2'' = TV-out and ''ctrl+alt+F4'' = DVI
  • Last modified: 2017/01/31 09:13
  • by christian