Differences
This shows you the differences between two versions of the page.
Next revision | Previous revision Next revisionBoth sides next revision | ||
faq:xpc_cube:sd37p2 [2016/08/26 14:41] – created Shuttle | faq:xpc_cube:sd37p2 [2017/02/01 10:54] – [Why is my DDR2-800 memory only displayed as DDR2-667 on the POST screen?] christian | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== SD37P2 ====== | ====== SD37P2 ====== | ||
- | ===== Why my SD37P2 run unstable | + | ===== How do I identify the version of my SD37P2? ===== |
- | Because | + | There are two versions of the SD37P2, V1 and V2. If you are not sure which version you purchased, please proceed as below to identify the version. |
+ | |||
+ | ^If the PCS is 1.X or the BIOS ID's 6th digit is 0, please download the BIOS SD37V1.x at: [[http:// | ||
+ | |{{: | ||
+ | ^If the PCB is 2.X or the BIOS ID's 6th digit is 2, please download the BIOS SD37V2.X at: [[http:// | ||
+ | |{{: | ||
+ | |||
+ | ===== Why won't my SD37P2 support some of ATI's video cards? ===== | ||
+ | The SD37P2 has two PCI-E slots. The PCI-E 16x bandwidth will be halved to 8x speed on each slot. If your video card only supports 16x speed, it will not run on this system. Please check your video card specifications or contact your video card vendor for detailed information. | ||
+ | |||
+ | ===== Does my SD37P2 support four DIMMs of DDR2-667 memory? ===== | ||
+ | Yes, it does. Should it however turn out that it won't run stable, the system will automatically clock down the memory to 533 MHz to stabilise. | ||
+ | |||
+ | ===== Why does my SD37P2 run unstable | ||
+ | This is because | ||
+ | |||
+ | ===== How do I get the best out of my memory in Dual Channel mode and what aspects should I pay attention to? ===== | ||
+ | To enable your SD37P2 DDR2 memory in Dual Channel mode, please refer to the steps below. | ||
+ | |||
+ | - Please make sure to put the very same DDR2 memory (type and brand) in the slot of the same colour. (If modules are installed in slots of different colour, they will run in Single Channel mode.) \\ {{: | ||
+ | - If the modules are installed correctly, Dual Channel will be shown on a screen when booting the XPC. \\ {{: | ||
+ | - Should the message "Dual Channel Mode Enabled" | ||
+ | |||
+ | ===== Why is my DDR2-800 memory only displayed as DDR2-667 on the POST screen? ===== | ||
+ | According to Intel' | ||
+ | |||
+ | - Enter BIOS and go to Frequency/ | ||
+ | - Under DRAM Timing Selectable select " | ||
+ | - Set System Memory Frequency to 800 MHz. \\ {{: | ||
+ | - Press the F10 key to save changes to CMOS and exit BIOS. \\ {{: | ||
+ | - Check the post screen whether it shows DDR2-800. \\ {{: | ||
==== Related links ==== | ==== Related links ==== | ||
{{backlinks> | {{backlinks> |