Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
faq:xpc_cube:sd37p2 [2017/02/01 10:41] – [How to get the best use of SD37P2 in Dual Channel mode and what aspects should be pay attention to?] christian | faq:xpc_cube:sd37p2 [2017/02/01 10:52] – [Why is my DDR2-800 memory only displayed as DDR2-667 on the POST screen?] christian | ||
---|---|---|---|
Line 21: | Line 21: | ||
- Please make sure to put the very same DDR2 memory (type and brand) in the slot of the same colour. (If modules are installed in slots of different colour, they will run in Single Channel mode.) \\ {{: | - Please make sure to put the very same DDR2 memory (type and brand) in the slot of the same colour. (If modules are installed in slots of different colour, they will run in Single Channel mode.) \\ {{: | ||
- | - If the modules are installed correctly, Dual Channel will de shown on a screen when booting the XPC. \\ {{: | + | - If the modules are installed correctly, Dual Channel will be shown on a screen when booting the XPC. \\ {{: |
- | - Should Dual Channel not be displayed | + | - Should |
- | ===== Why my DDRII 800 only show DDRII 667 at POST screen? ===== | + | ===== Why is my DDR2-800 memory |
- | According to Intel' | + | According to Intel' |
- | - Boot Into BIOS, and select the Frequency/ | + | - Enter BIOS and go to Frequency/ |
- DRAM Timing Selectable selects the Manual \\ {{: | - DRAM Timing Selectable selects the Manual \\ {{: | ||
- | - System Memory Frequency | + | - Set System Memory Frequency to 800 MHz. \\ {{: |
- | - Press F10 key save to CMOS and EXIT \\ {{: | + | - Press the F10 key to save changes |
- | - Check the post screen | + | - Check the post screen |
==== Related links ==== | ==== Related links ==== | ||
{{backlinks> | {{backlinks> |