Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision |
faq:xpc_cube:sd37p2 [2017/02/01 10:43] – [How do I get the best out of my memory in Dual Channel mode and what aspects should I pay attention to?] christian | faq:xpc_cube:sd37p2 [2017/02/01 10:54] – [Why is my DDR2-800 memory only displayed as DDR2-667 on the POST screen?] christian |
---|
- Should the message "Dual Channel Mode Enabled" not be displayed while booting, the memory is running in Single Channel mode only. \\ {{:faq:xpc_cube:sd37:sd37_dual_channel_03.jpg?nolink&400|}} | - Should the message "Dual Channel Mode Enabled" not be displayed while booting, the memory is running in Single Channel mode only. \\ {{:faq:xpc_cube:sd37:sd37_dual_channel_03.jpg?nolink&400|}} |
| |
===== Why my DDRII 800 only show DDRII 667 at POST screen? ===== | ===== Why is my DDR2-800 memory only displayed as DDR2-667 on the POST screen? ===== |
According to Intel's SPEC for chipset 975X, it can only support up to 2 DDRII 800. If your memory modules show DDR667, you will adjust the frequency speed by manually in the BIOS. You may follow below instruction for setup. | According to Intel's specifications of the 975X chipset, it supports a total of two DDR2-800 modules. If your memory modules are shown as DDR2-667, you will need to set the frequency speed manually in the BIOS. Please follow the below steps. |
| |
- Boot Into BIOS, and select the Frequency/Voltage Control \\ {{:faq:xpc_cube:sd37:sd37_ddr2_800_01.jpg?nolink&400|}} | - Enter BIOS and go to Frequency/Voltage Control. \\ {{:faq:xpc_cube:sd37:sd37_ddr2_800_01.jpg?nolink&400|}} |
- DRAM Timing Selectable selects the Manual \\ {{:faq:xpc_cube:sd37:sd37_ddr2_800_02.jpg?nolink&400|}} | - Under DRAM Timing Selectable select "Manual". \\ {{:faq:xpc_cube:sd37:sd37_ddr2_800_02.jpg?nolink&400|}} |
- System Memory Frequency select to 800MHz \\ {{:faq:xpc_cube:sd37:sd37_ddr2_800_03.jpg?nolink&400|}} | - Set System Memory Frequency to 800 MHz. \\ {{:faq:xpc_cube:sd37:sd37_ddr2_800_03.jpg?nolink&400|}} |
- Press F10 key save to CMOS and EXIT \\ {{:faq:xpc_cube:sd37:sd37_ddr2_800_04.jpg?nolink&400|}} | - Press the F10 key to save changes to CMOS and exit BIOS. \\ {{:faq:xpc_cube:sd37:sd37_ddr2_800_04.jpg?nolink&400|}} |
- Check the post screen is DDRII 800 \\ {{:faq:xpc_cube:sd37:sd37_ddr2_800_05.jpg?nolink&400|}} | - Check the post screen whether it shows DDR2-800. \\ {{:faq:xpc_cube:sd37:sd37_ddr2_800_05.jpg?nolink&400|}} |
| |
==== Related links ==== | ==== Related links ==== |
{{backlinks>.}} | {{backlinks>.}} |