Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
faq:xpc_cube:sn41g2 [2016/09/08 13:49] Shuttlefaq:xpc_cube:sn41g2 [2021/09/02 13:41] (current) TS
Line 1: Line 1:
 ====== SN41G2 ====== ====== SN41G2 ======
 +{{section>faq:hardware:graphics#g-series&firstseconly&nofooter&noeditbutton&noreadmore}}
 +===== How do VGA1, VGA2 and TV-out function properly at same time? =====
 +For SN41G2, the system supports only following combinations:
 +  - VGA1+VGA2
 +  - VGA1+TV-out
 +
 +===== Why is my Microphone not working when I connect into front panel jack? =====
 +Please make sure that Mic2 in Main tab under NVIDIA nForce control panel is checked.
 +
 ===== When 2 monitors or one monitor & one TV are connected, there are no selections in nVidia’s nView control panel ===== ===== When 2 monitors or one monitor & one TV are connected, there are no selections in nVidia’s nView control panel =====
 Therefore, only one output is display. Therefore, only one output is display.
Line 14: Line 23:
   - Follow up the directives that will install the RAID driver completely.   - Follow up the directives that will install the RAID driver completely.
  
-----+===== SN41G2 failed to boot-up, even after clear CMOS ===== 
 +Please shut down the SN41G2, Then press and hold the "insert" key and turn on the system. 
 + 
 +===== Why is my system unstable? ===== 
 +Please try to uninstall and then reinstall CPU, Heat-Pipe and CPU protect shim. 
 + 
 +  Re-install CPU. 
 +  - Apply thermal grease all over CPU DIE, completely. 
 +  - Place the "CPU protect shim" correctly. 
 +    - Follow the directional word, “UP” as mounting.\\ {{:faq:xpc_cube:sn41:sn41_unstable_01.jpg?nolink|}} 
 +    - Please make sure to remove blue plastic from CPU protect shim. 
 +  - Make sure the heat-pipe installed horizontally. 
 + 
 +All above can also refer to installation guide as well. 
 ==== Related links ==== ==== Related links ====
 {{backlinks>.}} {{backlinks>.}}
  • Last modified: 2016/09/08 13:49
  • by Shuttle