Differences

This shows you the differences between two versions of the page.

--- faq:xpc_cube:st20g5 [2016/08/29 12:50] – Shuttle
+++ faq:xpc_cube:st20g5 [2016/08/29 12:51] – [Windows 2000 and XP installation on a Serial ATA(SATA)/RAID Hard Drive] Shuttle
@@ Line 22: / Line 22: @@
     - Enter ''South Configuration'' \\ {{:faq:xpc_cube:st20:st20_raid_installation_07.jpg?nolink&400|}}
     - Enable ''Serial ATA RAID Mode'', press ''F10'' to save the configuration and exit. \\ {{:faq:xpc_cube:st20:st20_raid_installation_08.jpg?nolink&400|}}
-    - Press ''Ctrl-A'' to enter ULi RAID BIOS Setup Utility and select the drives that you wish to use in a RAID array. (Please refer to the ULi RAID manual P3).
+    - Press ''Ctrl-A'' to enter ''ULi RAID BIOS Setup Utility'' and select the drives that you wish to use in a RAID array. (Please refer to the ULi RAID manual P3).
     - Installing Windows
     - The following procedure outlines the important steps in installing Windows on a RAID drive. Before you begin, please make sure the RAID driver disk is inserted in the floppy drive, and the floppy drive is connected to the computer.
@@ Line 30: / Line 30: @@
     - Press "Enter" to select the ''ULi SATA Controller(M5287, Windows XP/Server 2003)''.
     - The following Windows Setup screen appears listing the drivers that you choose. \\ {{:faq:xpc_cube:st20:st20_raid_installation_12.jpg?nolink&400|}}
-  - After the drivers are selected, press Enter to continue installing Windows.
+    - After the drivers are selected, press Enter to continue installing Windows.
 ==== Related links ====
 {{backlinks>.}}