Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revisionBoth sides next revision
faq:xpc_cube:st20g5 [2016/08/29 12:50] Shuttlefaq:xpc_cube:st20g5 [2017/07/17 11:24] Shuttle
Line 1: Line 1:
 ====== ST20G5 ====== ====== ST20G5 ======
-{{section>faq:xpc_cube:sg33g5#post_issuejp4_jumper_setting_for_shuttle_g5_models&firstseconly&nofooter&noeditbutton&noreadmore}}+{{section>faq:xpc_cube:sg33g5#post_issue_on_shuttle_g5_models_-_check_setting_of_jumper_jp4&firstseconly&nofooter&noeditbutton&noreadmore}}
  
 ===== Windows 2000 and XP installation on a Serial ATA(SATA)/RAID Hard Drive ===== ===== Windows 2000 and XP installation on a Serial ATA(SATA)/RAID Hard Drive =====
Line 22: Line 22:
     - Enter ''South Configuration'' \\ {{:faq:xpc_cube:st20:st20_raid_installation_07.jpg?nolink&400|}}     - Enter ''South Configuration'' \\ {{:faq:xpc_cube:st20:st20_raid_installation_07.jpg?nolink&400|}}
     - Enable ''Serial ATA RAID Mode'', press ''F10'' to save the configuration and exit. \\ {{:faq:xpc_cube:st20:st20_raid_installation_08.jpg?nolink&400|}}     - Enable ''Serial ATA RAID Mode'', press ''F10'' to save the configuration and exit. \\ {{:faq:xpc_cube:st20:st20_raid_installation_08.jpg?nolink&400|}}
-    - Press ''Ctrl-A'' to enter ULi RAID BIOS Setup Utility and select the drives that you wish to use in a RAID array. (Please refer to the ULi RAID manual P3).+    - Press ''Ctrl-A'' to enter ''ULi RAID BIOS Setup Utility'' and select the drives that you wish to use in a RAID array. (Please refer to the ULi RAID manual P3).
     - Installing Windows     - Installing Windows
     - The following procedure outlines the important steps in installing Windows on a RAID drive. Before you begin, please make sure the RAID driver disk is inserted in the floppy drive, and the floppy drive is connected to the computer.     - The following procedure outlines the important steps in installing Windows on a RAID drive. Before you begin, please make sure the RAID driver disk is inserted in the floppy drive, and the floppy drive is connected to the computer.
Line 30: Line 30:
     - Press "Enter" to select the ''ULi SATA Controller(M5287, Windows XP/Server 2003)''.     - Press "Enter" to select the ''ULi SATA Controller(M5287, Windows XP/Server 2003)''.
     - The following Windows Setup screen appears listing the drivers that you choose. \\ {{:faq:xpc_cube:st20:st20_raid_installation_12.jpg?nolink&400|}}     - The following Windows Setup screen appears listing the drivers that you choose. \\ {{:faq:xpc_cube:st20:st20_raid_installation_12.jpg?nolink&400|}}
-  - After the drivers are selected, press Enter to continue installing Windows. +    - After the drivers are selected, press Enter to continue installing Windows. 
  
 ==== Related links ==== ==== Related links ====
 {{backlinks>.}} {{backlinks>.}}
  • Last modified: 2021/09/02 13:43
  • by TS