Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
faq:xpc_cube:sb61g2 [2016/08/26 14:24] – Shuttle | faq:xpc_cube:sb61g2 [2021/09/02 13:38] (current) – TS | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== SB61G2 ====== | ====== SB61G2 ====== | ||
- | ===== How can I check my DDR is performing in dual channel mode? ===== | + | {{section> |
- | - Press the " | + | ===== Why does the system fail to power up? ===== |
- | - Check the message | + | or //Why do the front audio ports fail to work?// or //Why do the front panel USB ports fail to work?// |
+ | |||
+ | At the front of the XPC SB61G2V3 is a flat cable connecting the daughterboard to the motherboard. If this cable is not connected properly, it will result in partial or full failure of the daughterboard. To correct this issue, please open the chassis and check the cable. | ||
+ | |||
+ | - Please double-check, | ||
+ | - Make sure the "Flat cable" is fastened by "Lock bar". | ||
+ | - Wind the "Flat cable" as follows to avoid future issues. | ||
+ | |||
+ | ===== How can I check if my DDR memory | ||
+ | - Press the " | ||
+ | - Check the message | ||
<WRAP center round tip 60%> | <WRAP center round tip 60%> | ||
- | Note: Please refer to the user's manual page 38, you have to use the same size and type DIMMs on Channels 0 and 1. | + | Note: Please refer to the user's manual page 38. You need to use the same size and type of DIMMs on Channels 0 and 1. |
</ | </ | ||
- | ===== Why won't the system boot after overclocking the CPU Clock? ===== | + | ===== Why won't the system boot after overclocking the CPU? ===== |
- | When overclocking the CPU FSB Clock, the memory frequency will also overclock at the same time. When overclocking make sure that you set the memory frequency to lower level, | + | When overclocking the CPU' |
{{: | {{: | ||
- | ===== Why is there a delay on the S/PDIF-out signal? | + | ===== Why is there a delay on the S/ |
- | Issue: When a file is selected to play via SPDIF-out, it takes 0.5s before a sound begins | + | Issue: When a file is selected to be played |
- | Fix: A beta driver has been developed | + | A beta driver has been released |
==== Related links ==== | ==== Related links ==== | ||
{{backlinks> | {{backlinks> |