SH570R6

This update has two features:

• If the installation of Windows 11 cannot be completed because errors such as “The PC must support TPM 2.0” are displayed, please perform the following steps.
• If the MAC addresses of the network cards soldered on the mainboard are incorrectly formatted or not accepted by the operating system, please perform the following steps.

1. Re-Flash the BIOS v1.05 (or later if available) by USB drive (even if 1.05 is already installed): Download BIOS
   
   

   How do I update the BIOS version in UEFI (UEFI Mode)?

2. After BIOS flash, please clear the CMOS via “Clear CMOS & power button (SW1)”
   • Disconnect the machine from power and shortcut the bottom pins (1 + 3) on the backside for at least 60 seconds with a screwdriver, jumper or another metal part.
     
   • Pinout:
     
   • NOTE: The four pins may be covered. Please remove the plastic/mylar first.
3. Now enter the BIOS again and press the following keys in order: F3 → ENTER → F4 → ENTER
4. After that, please install and run Windows and check for MAC address:
   • Please download and run the “MAC address update tool” in Windows 10/11: Download tool

1. Get the update tool from here.
2. Start the update.
3. Unpack the contents of the ZIP archive.
4. Run sch_macupdate_x64.exe. It lists all available network adapters.
   
5. A faulty adapter is marked red. To fix the MAC address (MAC-ID), click “Update”.
   
6. After a few seconds, the update is done and all MAC addresses have been set to correct values again.

No network adapter found?

1. If no network adapter is listed, close the tool.
2. Execute install.bat batch file from the same folder to a driver setup.
3. After finishing the driver installation, start sch_macupdate_x64.exe again.

1=GND
2=+12V
3=FAN IO
4=FAN PWM

1=DCD
2=RXD
3=TXD
4=DTR
5=GND
6=DSR
7=RTS
8=CTS
9=-XRI1
10=NULL

1=RTC Reset
2=VCC_AUX
3=GND
4=Power SW