This is an old revision of the document!


SN41G2

For SN41G2, the system supports only following combinations:

  1. VGA1+VGA2
  2. VGA1+TV-out

Therefore, only one output is display.

To enable the selections to appear in nView and both monitors or one monitor & one TV can display, please have all devices connected before system boot-up.

  1. Press F6 to install RAID driver during Windows setup.
  2. Press “S” button to specify additional device.
  3. Select the NVIDIA RAID Driver (required).
  4. After loading the NVIDIA RAID Driver (required), please press “S” button to continue installation.
  5. Select the NVIDIA nForce Storage Controller (required).
  6. After loading both drivers, please press ENTER to continue.
  7. Follow up the directives that will install the RAID driver completely.

Please shut down the SN41G2, Then press and hold the “insert” key and turn on the system.

Please try to uninstall and then reinstall CPU, Heat-Pipe and CPU protect shim.

  1. Re-install CPU.
  2. Apply thermal grease all over CPU DIE, completely.
  3. Place the “CPU protect shim” correctly.
    1. Follow the directional word, “UP” as mounting.
    2. Please make sure to remove blue plastic from CPU protect shim.
  4. Make sure the heat-pipe installed horizontally.

All above can also refer to installation guide as well.

  • Last modified: 2016/09/08 14:26
  • by Shuttle