Differences

This shows you the differences between two versions of the page.

--- faq:xpc_cube:sn41g2 [2016/09/08 13:49] – Shuttle
+++ faq:xpc_cube:sn41g2 [2016/09/08 14:39] – Shuttle
@@ Line 1: / Line 1: @@
 ====== SN41G2 ======
+===== How do VGA1, VGA2 and TV-out function properly at same time? =====
+For SN41G2, the system supports only following combinations:
+  - VGA1+VGA2
+  - VGA1+TV-out
+===== Why is my Microphone not working when I connect into front panel jack? =====
+Please make sure that Mic2 in Main tab under NVIDIA nForce control panel is checked.
 ===== When 2 monitors or one monitor & one TV are connected, there are no selections in nVidia’s nView control panel =====
 Therefore, only one output is display.
@@ Line 14: / Line 22: @@
   - Follow up the directives that will install the RAID driver completely.
-----
+===== SN41G2 failed to boot-up, even after clear CMOS =====
+Please shut down the SN41G2, Then press and hold the "insert" key and turn on the system.
+===== Why is my system unstable? =====
+Please try to uninstall and then reinstall CPU, Heat-Pipe and CPU protect shim.
+  - Re-install CPU.
+  - Apply thermal grease all over CPU DIE, completely.
+  - Place the "CPU protect shim" correctly.
+    - Follow the directional word, “UP” as mounting.\\ {{:faq:xpc_cube:sn41:sn41_unstable_01.jpg?nolink|}}
+    - Please make sure to remove blue plastic from CPU protect shim.
+  - Make sure the heat-pipe installed horizontally.
+All above can also refer to installation guide as well.
 ==== Related links ====
 {{backlinks>.}}