Differences

This shows you the differences between two versions of the page.

--- faq:xpc_cube:sn41g2 [2015/09/03 15:59] – created Shuttle
+++ faq:xpc_cube:sn41g2 [2021/09/02 13:41] (current) – TS
@@ Line 1: / Line 1: @@
 ====== SN41G2 ======
+{{section>faq:hardware:graphics#g-series&firstseconly&nofooter&noeditbutton&noreadmore}}
+===== How do VGA1, VGA2 and TV-out function properly at same time? =====
+For SN41G2, the system supports only following combinations:
+  - VGA1+VGA2
+  - VGA1+TV-out
+===== Why is my Microphone not working when I connect into front panel jack? =====
+Please make sure that Mic2 in Main tab under NVIDIA nForce control panel is checked.
+===== When 2 monitors or one monitor & one TV are connected, there are no selections in nVidia’s nView control panel =====
+Therefore, only one output is display.
+To enable the selections to appear in nView and both monitors or one monitor & one TV can display, please have all devices connected before system boot-up.
 ===== How to install RAID driver under Windows XP? =====
   - Press F6 to install RAID driver during Windows setup. \\ {{:faq:xpc_cube:sn41:raid_driver_xp_01.jpg?nolink&300|}}
@@ Line 9: / Line 23: @@
   - Follow up the directives that will install the RAID driver completely.
-----
+===== SN41G2 failed to boot-up, even after clear CMOS =====
+Please shut down the SN41G2, Then press and hold the "insert" key and turn on the system.
+===== Why is my system unstable? =====
+Please try to uninstall and then reinstall CPU, Heat-Pipe and CPU protect shim.
+  - Re-install CPU.
+  - Apply thermal grease all over CPU DIE, completely.
+  - Place the "CPU protect shim" correctly.
+    - Follow the directional word, “UP” as mounting.\\ {{:faq:xpc_cube:sn41:sn41_unstable_01.jpg?nolink|}}
+    - Please make sure to remove blue plastic from CPU protect shim.
+  - Make sure the heat-pipe installed horizontally.
+All above can also refer to installation guide as well.
 ==== Related links ====
 {{backlinks>.}}